Pneumatic Punch Overload Troubleshooting?

Pneumatic Punch press Overload Troubleshooting?

1. The air pressure is too high, causing the machine to keep moving. Solution: Check whether the pressure of the high-speed punching machine pressure gauge is normal, or the pressure regulating valve is abnormal. 2. The high-speed punching machine hydraulic pump is damaged. Solution: Replace the pump with a new one.

2. The internal part is not clean, causing the machine to keep moving. Solution: Disassemble and clean it.

3. The air pressure is too low, causing an emergency stop. Solution: Check whether the pressure of the high-speed punching machine pressure gauge is normal, or the pressure regulating valve is abnormal. 5. The oil currently used in the high-speed punching machine does not meet the requirements. Solution: Refer to the oil specifications on the nameplate on the left side of the high-speed punching machine, and then purchase and replace it.

6. The overload solenoid valve is damaged. Solution: Replace the solenoid valve with a new one.

7. The oil tank is leaking. Solution: Check whether the high-speed punching machine oil tank is broken or the screws are not tightened.

8. Lining loss. Solution: Disassemble and check whether the lining is aging or damaged.

Products

Open single point precision punch press

Open single point precision punch press

Learn More
Open single point precision punch press

Open single point precision punch press

Learn More
BLC-160 Open single point precision punch press

BLC-160 Open single point precision punch press

Learn More
JH21-250 Precision Punch Press

JH21-250 Precision Punch Press

Learn More

We Value Your Feedback

Please share your thoughts about this article: